Storch 69 06 50 Mode D'emploi page 59

7. Fit the screws (24).
8. Attach the trigger (25) on the gun body. Insert the
pivot pin (28) into the top hole (A) and secure with the
screw (29) on other side. Place an lock washer (27) on
one end of the trigger pin (18). Guide the pin through the
lower trigger holes and the slot (B) in the spring guide
(16). Turn spring guide to align as needed. Insert the
other lock washer (27).
9. If the spring tension screw (21) was removed, insert it
into the rear of the gun. Tighten until you reach the stop.
Tighten until you
reach the stop.
Test gun before use
1. Engage the gun trigger lock. Connect the hose to the
gun. Switch on and fill the pump.
2. Disengage the trigger lock. Point the gun into a waste
container and pull the trigger. Release the trigger to
ensure the gun immediately stops spraying and make
sure there are no leaks.
3. Screw on the nozzle holder.
59 Original instruction