Assembly Instructions; Maintenance - Texas A/S Hobby 300 B Manuel D'utilisation

Assembly instructions

1. Figure 1 shows the contents of the kit:
a. Blades.
b. Depth skid with transport wheels.
c. Tiller with cables.
d. Upper handlebar
e. User manual and mounting bolts.
f. Lower handlebars, right and left.
2. Fit the two lower handles using the accompanying bolt. Make sure that the handles
are turned the right way.
Fit handle (a.) on the right and handle (b.) on the left.
Figure 2, 3.
3. Fit the upper handle using the accompanying bolt set.
Pay attention to the arrows on the plastic brackets. They must be aligned when
mounting.
Figure 4, 5.
4. Mount the throttle cable (a.) and clutch cable (b.) as shown in the figure.
Figure 4
5. Apply grease to the transmission, as described in this manual.
Figure 6.
6. Mount blades, depth skid and transport wheels using the accompanying cotter bolts
and pins
Figure 7, 8.

Maintenance

The engine shall be stopped when carrying out maintenance and cleaning operations, when
changing tools and when being transported by means other than under its own power.
Add grease until it runs out of the filler hole when the machine is horizontal.
Remove the spark plug cover on the engine.
-
Add grease to the gear.
-
Place the pack of grease in a bucket of warm water. This will make the consistency
thinner, so it is easier to add to the gear. Avoid cutting off too much of the tip on the
pack. It is important that the tip is as pointed as possible.
Add grease until it comes out of the filler hole when the machine is horizontal.
Operate the clutch lever and pull the starter cord 3 times to distribute the grease
-
around the gear.
Then add more grease until the gear is full.
-
Fit and tighten the screw.
-
Fit the spark plug cover on the engine.
-
Figure 6
19