Cleaning And Maintenance - Zanussi ZTE 273 Notice D'utilisation

middle of a programme after lighting up of light
Bac plein (Water Reservoir) .
In both cases the light of the Marche/Arrêt
(Start/Pause) button flashes to remind you that
the start button needs to be pressed again.
Indicator lights
These lights indicate the following functions:
• Séchage (Drying) light: This light indicates
that the appliance is in the drying phase.
• Anti-Froissage/Fin (Anticrease/End)
light: This light is on at the end of the cooling
phase, during the anticreasing phase and at
the end of the programme.
• Bac plein (Water Reservoir) light: This
light indicates that the appliance is in the dry-
ing phase. This light comes on at the end of
the programme to remind you that the water
reservoir must be emptied out. If this light illu-
minates during a programme this means that
the water reservoir is full. The buzzer sounds,
the programme stops, the light of the Start/
Pause button flashes. This light comes on al-
so when the water reservoir is not inserted
correctly.
• Filtres (Filter) light: This light illuminates at
the end of the programme to remind you that
the filters must be cleaned.
• Condenseur (Condenser) light: It comes
on every 80 cycles to remind you that the
condenser must be cleaned.
Changing programme
To change a programme which has been selec-
ted by mistake once the programme has started,
first turn the programme selector to " O" (OFF)
position. The programme is cancelled.

Cleaning and maintenance

Cleaning lint filters
To ensure that the appliance works perfectly,
the lint filters in the door and in front of the drum
must be cleaned after every drying cycle.
Caution! Important. Never operate the
dryer without the lint filter or with a
damaged or blocked lint filter.
10
The programme can no longer be changed
directly once the programme has started. If
nevertheless there is an attempt to change the
programme on the programme knob or if an
function button (excluding the Alarme (Buz-
zer) button) is pressed, led above Marche/Arrêt
(Start/Pause) button starts flashing temporarily
in yellow. The drying programme is not however
affected by this (laundry protection).
At the end of the programme
If the laundry is not removed at the end of the
cycle, the dryer performs an anticreasing phase
(duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will
stop automatically at the end of the anticreasing
phase. Lights Anti-Froissage/Fin (Anti-
crease/End) , and Bac plein (Water Reser-
voir) remain lit and the buzzer sounds for 2 mi-
nutes.
Turn the programme selector dial to "O" to
switch the machine off. Remove the laundry
from the drum and carefully check that the drum
is empty.
If you do not intend to carry out another wash,
close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant
smells.
If you open and then close the door before
turning the selector dial to "O" all the lights
corresponding to the phases making up the per-
formed programme come on.
After each use
• Clean the filters.
• Empty the water reservoir.
www.zanussi.com