Zanussi ZTE283 Notice D'utilisation page 19

Important!
• The hot air emitted by the tumble dryer can reach tem-
peratures of up to 60°C. The appliance must therefore
not be installed on floors which are not resistant to
high temperatures.
• When operating the tumble dryer, the room tempera-
ture must not be lower than +5°C and higher than
+35°C, as it may affect the performance of the appli-
ance.
• Should the appliance be moved, it must be transported
vertically.
• The appliance must not be installed behind the lock-
able door, a sliding door a door with a hinge on the
opposite side to that of the appliance in such a way that
a full opening of the dryer is restricted.
Removing transport safety packaging
Caution! Before use all parts of the transport
packaging must be removed.
1. Open loading door
3. Remove foil hose and polystyrene padding from the
machine.
Electrical connection
Details on mains voltage, type of current and the fuses
required should be taken from the type plate. The type
plate is fitted near the loading aperture (see "Product de-
scription" chapter).
2. Pull off adhesive strips
from inside machine on
top of drum.
Warning! The manufacturer declines any
responsibility for damage or injury through failure
to comply with the above safety precautions.
Should the appliance power supply cable need to be
replaced, this must be carried out by our Service Center.
Warning! The power supply cable must be
accessible after installing the machine.
Door reversal
To make it easier to load or unload the laundry, the door
can be reversed.
Warning! The door must only be reversed by an
authorised service engineer.
Please contact your local Service Force Centre. The en-
gineer will carry out the door reversal at your cost.
Special accessories
• stack kit
Available from your Service Force Centre or your
specialist dealer
These intermediate installation kits can be used to ar-
range the dryer and an washing machine (60 cm wide,
front loaded) as a space-saving washer/dryer stack.
The washing machine is at the bottom and the dryer is
at the top.
Read carefully the instructions supplied with the kit.
• drain kit
Available from your Service Force Centre or your
specialist dealer
Installation kit for direct draining of condensate into a
basin, siphon, gully, etc. The condensate tank then no
longer has to be drained, it must however remain in its
intended position in the machine.
Read carefully the instructions supplied with the kit.
• pedestal with the drawer
Available from your Service Force Centre or your
specialist dealer
To situate the dryer in optimal high and have some
additional space to store (e.g. laundry).
Read carefully the instructions supplied with the kit.
19