Troubleshooting; Scrapping - Nilfisk SW900 Instructions D'utilisation

ENGLISH

TROUBLESHOOTING

Trouble
The engine does not start when pulling the
handle.
The engine stops during operation.
The side broom does not operate.
The machine collects little debris/dust.
The electrical filter shaker does not work.
When pulling the drive control lever, the machine
does not move, or it moves slowly.
(*) For the relevant procedure, see the Petrol Engine Manual.
(**) Procedure to be performed by Nilfisk Service Center.
For further information contact a Nilfisk Service Center, where it is possible to consult the Service Manual.

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Engine oil
– Polyester dust filter
– Main and side brooms
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Nilfisk Center especially when scrapping electrical and electronic components.
20
USER MANUAL
Possible cause
The ignition key is not turned to "I".
The fuel tap is closed.
The fuel tank is empty.
The hopper is not in its proper position.
The fuel does not reach the carburettor.
The spark plug does not produce a spark.
The hopper microswitch is broken.
The engine oil level is insufficient.
The fuel tank is empty.
The fuse (FB) or (FC) (optional) is open.
The main fuse (FA) is open.
The side broom microswitch is faulty.
The dust filter is clogged.
The hopper is full.
The skirts are not properly adjusted or are
broken.
The brooms are not properly adjusted.
The main broom belt is misadjusted or worn.
The fuse (F1) is open.
The drive control cable is misadjusted or
broken.
The driving belt is misadjusted or worn.
SW900 - 1465371000
Remedy
Turn the ignition key to "I".
Open the fuel tap.
Refuel.
Place the hopper properly.
Check if the fuel reaches the carburettor. (*)
Clean/replace the spark plug. (*)
Replace the microswitch. (*)
Add engine oil. (*)
Refuel.
Wait for the side broom motor to cool down,
then reset the fuse by pressing the relevant
push-button.
Replace the main fuse.
Replace the relevant side broom
microswitch. (**)
Clean the dust filter by using the filter shaker
or by disassembling it.
Empty the hopper.
Adjust/replace the skirts.
Adjust the broom height.
Adjust or replace the main broom belt. (**)
Replace the fuse.
Adjust or replace the drive control cable. (**)
Adjust or replace the driving belt. (**)
08/2013