Self-Cleaning Of The Cell; Chlorine Production And Mode Of Operation; Standard; Pool Equipped With A Pool Cover : Low - POOL Autosalt Manuel Utilisateur

SELF-CLEANING OF THE CELL

4
This device is equipped with an automatic cleaning of the chlorination cell by a polarity inversion of the cell's
poles. For an optimum cleaning of the chlorinator cell, these inversion frequencies must be adjusted
depending on the water hardness of your water.
✓ Measure the water hardness (TH) with a supplied tongue.
✓ Adjust your inversion frequencies in the setting menu according to the following board :
TH (°f)
Inversion frequency (hours)
Important: the automatic cleaning of the cell does not have authority to compensate a hardness of very high water.
Beyond a TH of 60°f, it is imperative to act first of all on the balance of the water to lower its hardness.
CHLORINATION SALT CHLORINATION SALT
◄► ◄►
OK OK

CHLORINE PRODUCTION AND MODE OF OPERATION

5
✓ According to its configuration, the device has several modes of operation. The chlorine production will
depend on the activated mode of operation :
Mode

Standard

Pool equipped with a pool cover
Free chlorine regulation option
(Poolsquad ®Ampéro)
Free chlorine regulation option
(Poolsquad ®Pro)
OFF
✓ Change the mode to reach the setting menu :
CHLORINATION SALT CHLORINATION SALT
◄► ◄►
AUTOSALT®/POOLSQUAD®/POOLSQUAD® AMPERO/PRO - PAPI004082 – FR/EN/ES/DE - Rev.03.16
0 - 5
16
INVERSION TIME INVERSION TIME
◄► ◄►
Continuous Production of chlorine by
regulation of a percentage
Reduced production when the pool cover is
closed (in case the cable was settled, see
§3.7, p.8).
Setting of a free chlorine instruction and
regulation by amperometric probe.
Setting of a free chlorine instruction and
regulation by ORP probe.
To deactivate the chlorination salt function
OK OK
5 - 12 12 - 20
10 8
6H00 6H00
▼▲ ▼▲
OK OK
Configuration
MODE MODE
% / LOW / Cl / OFF % / LOW / Cl / OFF
◄► ◄►
OK OK
20 - 40 40 - 60
6 4
INVERSION TIME INVERSION TIME
VALID VALID
Setting
MODE
◄►
OK
▼▲ ▼▲
> 60
2
Rx
▼▲
17