Adjustment Of The Time Between Each Chlorine Injection (Dilution Time); Setting The Chlorine Dosing Start Delay; Specification Of The Concentration Rate Of Chlorine Used; Alarms - POOL ORP Mode D'emploi

3.4.6. Adjustment of the time between each chlorine injection (dilution time)

Possible settings : from
Default setting :
1) Press and hold down the right-hand key, until the menu
2) Press the top or bottom key x times until the menu
3) Confirm by pressing the right-hand key.
4) Select a time limit with the top/bottom keys.
5) Confirm by pressing the right-hand key : the selected time limit freezes briefly.
6) Press on the left-hand key : the default display reappears.

3.4.7. Setting the chlorine dosing start delay

Possible settings : from
Default setting :
1) Press and hold down the right-hand key, until the menu
2) Press the top or bottom key x times until the menu
3) Confirm by pressing the right-hand key.
4) Select a time limit with the top/bottom keys.
5) Confirm by pressing the right-hand key : the selected time limit freezes briefly.
6) Press on the left-hand key : the default display reappears.

3.4.8. Specification of the concentration rate of chlorine used

Possible settings : from
Default setting :
1) Press and hold down the right-hand key, until the menu
2) Press the top or bottom key x times until the menu
3) Confirm by pressing the right-hand key.
4) Select a rate with the top/bottom keys.
5) Confirm by pressing the right-hand key : the selected rate freezes briefly.
6) Press on the left-hand key : the default display reappears.

3.5. Alarms

Flashing
Fault detected
display
Series of unsuccessful
attempts to correct the ORP
Deviation of + or - 400 mV
the ORP measurement
and the ORP setpoint
for 48 hours
to (i.e. from 5 to 60 min, in steps of 1 min).
to (i.e. from 5 to 60 min, in steps of 1 min).
to (i.e. from 5° to 48°, in steps of 1°).
Immediate
automatic
Stop the
chlorine
between
flashes.
flashes.
flashes.
flashes.
flashes.
flashes.
action
Check the ORP measurement in the
swimming pool with a recent analysis kit.
Check the pH corrector container is not
empty.
Check the condition of the filter with
ballast and injection connector.
Carry out a manual chlorine injection.
Check all the settings :
- Setting the chlorine dosage.
dosage
- Calibrating the ORP probe.
- ORP measurement adjustment.
- Setting the ORP setpoint.
- Adjustment of the time between each
chlorine injection (dilution time).
- Setting the chlorine dosing start delay.
- Specification of the concentration rate
of chlorine used.
Checks and solutions Dismissal
Press on
the right-
hand key
8