5/ Start Up; Checking The Water Parameters; Adding Salt - POOL Autosalt Manuel Utilisateur

5/ START UP

1

CHECKING THE WATER PARAMETERS

When installing the device or at the beginning of any new season, it is imperative to check and correct all the
following points :
State of the water
Temperature of the
water
pH
Stabilizer rate
Free chlorine rate
Be careful: the non compliance with these recommendations will involve inevitably a misuse of the device
which entails the annulation of guarantee.
Be careful with natural water sources (drilling waters)!
Preferably use water from the public water supply. Avoid using any water from natural sources (rain, run off water,
reservoirs, and wells) under risk of early deterioration of chlorinator cell.

ADDING SALT

2
✓ Ideal concentration of salt at the season's start = 5 kg/m
✓ Starting up : salt quantity = 5 x the volume of the pool in cubic meter (m
✓ Salt adding :
Actual salt
rate (Kg/m
0,5
1,5
2,5
3,5
4,5
✓ Salt type: with standard quality, salt in compliance with current legislation. You have not to use stabilized
salt with chlorine probe ( Poolsquad ®Ampéro Model)
✓ Directly add the salt in the pool and let work the filtration manually during 8 hours (the device must be
switched off).
AUTOSALT®/POOLSQUAD®/POOLSQUAD® AMPERO/PRO - PAPI004082 – FR/EN/ES/DE - Rev.03.16
Clear, free from seaweeds and sediments.
Above 15°C
Stabilized between 7,0 and 7,4
Important : whatever is the system of chemical process, the efficiency of the chlorine decreases
very quickly with the increase of the pH and the scale deposits appear all the more fast as the pH
rate is high or unstable.
For an Autosalt® or a standard Poolsquad® or Poolsquad® Pro: less than 35 ppm.
Important: The role of the stabilizer or isocyanurique acid is to protect the
chlorine from the effects of UV. A too important rate will have for consequence
to surround the disinfecting effect of the chlorine produced by the device. Lower
the rate of stabilizer in your pool by following the recommendations of your
professional.
For a Poolsquad ® Ampéro (chorine probe) : 0 ppm
It is imperative not to use stabilizer with free chlorine regulation of Poolsquad ®
Ampero (see § 5.5).
Greater than 1 particle by million (mg/l). If necessary, make a chlorination shock.
Quantity of salt to add (in kg)
3
)
30 40
0 150 200
135 180
1 120 160
150 140
2 90 120
75 100
3 60 80
45 60
4 30 40
15 20
3
.
Pool's water volume (m
50 60 70 80
250 300 350 400
225 270 315 360
200 240 280 320
175 210 245 280
150 180 210 240
125 150 175 200
100 120 140 160
75 90 105 120
50 60 70 80
25 30 35 40
3
).
3
)
90 100 110 120
450 500 550 600
405 450 495 540
360 400 440 480
315 350 385 420
270 300 330 360
225 250 275 300
180 200 220 240
135 150 165 180
90 100 110 120
45 50 55 60
15