Operation; Lcd Display - Omnitronic DSS-2 Mode D'emploi

In order to obtain highest sound-quality, only use high-quality cables for connecting the devices. Make sure
that the cables are properly fixed.
The Master-output can be connected via the RCA-sockets. Make sure that the sockets are set properly
(L & R).
You can connect up to 2 record players using the PHONO 1 sockets and PHONO 2 on the rearpanel. You
can only control the record player signal after you switched the PHONO/LINE switches to PHONO. The
signal is then controlled via the CH-1 and CH-2 faders.
Connect your CD-player, DAT-recorder, cassette deck, tuner, tape recorder or all other line signals to the
LINE input-sockets on the rearpanel. You can only control the line signals after you switched the
PHONO/LINE switches to line. The signal is then controlled via the respective faders.
Switch the device on. After switching on the amplifier, wait 8 to 10 seconds until you turn the volume-controls
in order to avoid speaker-damage.

6. OPERATION

6.1 Setup
Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.
6.2 CD-tray
Press the Open-button to open the Disc compartment-door. The door opens. Insert your CD into the CD-
compartment and close the compartment-door.
Make sure that you only hold the CD with 2 fingers on the edge. Avoid touching the inside area of the CD.
6.3 LCD-display
If the CD is improperly positioned,"ERR" or "NO DISC" appears on the display.
If the CD is properly positioned, the total number of tracks and the total playback time are shortly displayed.
The player jumps to the first track and is in the Pause-mode (Play/Pause-LED flashes). Please note that the
player automatically jumps to the section where the music starts.
Above "TRACK" the track number is displayed. Above M (MIN), S (SEC) and F (FRAME) the track remain
time is displayed.
By using the Time-button, the time-indication can be switched from track remain time (Remain) to track
playback time (Elapsed), outro-function (Outro) or total remain time (Total Remain). For activating the Outro-
function, the display needs to show „Outro". In this mode, the last 30 seconds of every track are played.
Above the time-indication, 10 bars are displayed showing the remaining track-time visually. The shorter the
track remain time becomes, the less bars are displayed. 30 seconds before the track-end, the bars in the
display start flashing.
The indication "SINGLE" means that the CD-player is in Single-mode. The current track is then played once
and the player goes into Pause-mode at the beginning of the next track. By pressing the Single-button, the
CD-player changes into normal playback mode and the display shows "CONTINUE".
The indication "0" means that the playback-speed has not been changed. If you adjust the playback-speed
via the Pitchfader (Pitch-button has to be pressed), the respective percentage is indicated in the display.
6.4 Play/Pause
In the Pause-mode the time-indication in the display stands still and the Play/Pause-LED flashes. The
playback of the first track can be started by pressing the Play/Pause button. In the Playback-mode, the time-
indication in the display is running and the Play/Pause-LED shines permanently.
If you wish to interrupt the playback, press the Play/Pause-button and the laser stops at the position where
you stopped.
28/64 10553155_V_1_0.DOC