Precautions - Omnitronic DSS-2 Mode D'emploi

6.13 Crossfader
Mixes the signals of one channel with another. If the crossfader is in the center-position, both channels can
be heard.
6.14 Channel-Fader
Used to adjust the input level of each channel.
6.15 CUE-Switch
Use the CUE-switch in order to select the channel to be monitored.
6.16 Power-LED
The Power-LED is illuminated when the mixer is ready for use.
6.17 Master-Control
Adjusts the level of the master output.
6.18 CUE Level-Control
With the CUE LEVEL-control, you can adjust the headphones volume without changing the output signal.
6.19 MIC Level-Control
With the MIC LEVEL control, you can adjust the microphone volume.
6.20 End of operation
Before you switch off the device, please make sure that no CD remains in the player.
Also make sure that the CD-tray is completely closed before you switch off. If this is not the case, switch the
device on again and close the tray with the Open/Close-button.

7. PRECAUTIONS

This DJ Set cannot be compared to conventional Hifi CD players - even if they have almost the same
appearance. This player is much more rugged in order to withstand the strenous road use and consistent
transports of mobile discotheques. We recommend to put the CD player on plastic foam or on rubber feet in
order to avoid skipping, which is caused by vibrations of low frequencies. The same thing holds true if the
CD player is mounted in a rack an the rack is exposed to such frequencies.
Should you have further problems, please refer to the chart below.
The adjustments of the Pitchfader change the FM frequencies. Should the display repeatedly show "ERR"
adjust the frequencies.
Have the connections correctly been carried out?
Is your amplifier and your mixer properly adjusted?
Have you kept to all instructions given in this manual?
31/64 10553155_V_1_0.DOC