Installation; Operation - Omnitronic DMS-1050 Mode D'emploi

23. AUDIO OUT-SOCKETS
The music-signal of these sockets is analogue. Connect the output to the respective input of your mixer.
24. DIGITAL OUT-SOCKET
The music-signal of this socket is digital. Connect the output to the respective input of a digital amplifier for
example.
25. RELAY-SOCKET
To connect a mixer or CD-player.
26. POWER SWITCH
Press this button to start operation.
27. AC VOLTAGE-SELECTOR
Make sure the selector is set properly.
28. AC CONNECTION
Plug the power supply cable in here.

5. INSTALLATION

Install the CD-player on a plane surface.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
The control panel's LCD's are designed to be clearly visible within the angles shown in Figure 1. Mount the
control panel so that the visual angle is within this range.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages.
Connect your CD-player with the mains.
CAUTION: Turn the amplifier on last and off first!

6. OPERATION

6.1 Setup
Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.
24/56 10602425_V_1_0