Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. INSTALLATION
(1) Install the CD-player on a plane surface or in your rack.
(2) Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
(3) Remove the protection foil from the display.
(4) Please note that the VFD-display can only be read from an angle of 45° to the top and of 5° to the
bottom.
(5) Rack-installation: This CD-player is built for 19" racks (483 mm). The rack you use should be a Double-
Door-Rack where you can open the frontpanel and the rear panel. The rack should be provided with a
cooling fan. When mounting the CD-player into the rack, please make sure that there is enough space
around the device so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the CD-player with four screws M6 in the rack. Be aware that fastening the device with four
screws on the front panel is not enough. In order to ensure safety, additional fastening by using ground
and side bars is necessary.
(6) CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you
connect it to the mains in order to avoid damages on your loudspeakers.
(7) Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
(8) Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to
avoid severe damages. Only plug the power-plug into safety-sockets. Connect your CD-player with the
mains.
6. OPERATION
6.1 Setup
Switch the CD-player on via the Power-switch. If a CD is inserted the CD LED is lit. After the CD has been
read in ("READING"), various information is indicated on the display. If no CD is inserted, „NO DISC"
appears on the display. For titles in the MP3 format „MP3" is displayed and the file name of the title selected
is indicated in the text line.
6.2 CD-tray
(1) Press Open/Close-button in order to open the disc tray. The CD-tray opens and the display shows
"OPEN". Insert your CD in the CD-tray. Make sure you only hold the CD with two fingers on the edge.
Avoid touching the inside area of the CD.
(2) CAUTION: Do not close the tray by pushing it as this could harm the construction. Press the
Open/Close-button again in order to close the tray.
6.3 VFD-display
17
16
15
18
1
2
3
14
4
5
13
12
6
7
29/63
11
10
9
8
10602405_V_1_0.DOC
Publicité
Table des Matières
