Ingeteam INGECON SUN 3Play TL M Série Manuel D'utilisateur page 8

Ingeteam
8. The main menu will be displayed once the firmware has been loaded. At that moment you can remove the
SD card by pressing it gently.
9. To maintain the protection rating of the unit after this task you must always replace the cover over the
card reader.
Troubleshooting in the firmware loading process
In the event that the inverter does not recognise the memory card, follow the instructions in the order they appear:
1. Cut the direct current using the isolating switch until the display switches off. Once the display is
switched off, insert the memory card and turn it on again.
2. Change the memory card. The memory card may be deteriorated or the model being used may be
incompatible with the inverter. Use a different card to load the firmware.
3. Connect the unit to the INGECON SUN Manager software and load the firmware via said software. You can
find the instructions to load the firmware at the INGECON SUN Training website in the courses section (http://
www.ingeconsuntraining.info/?page_id=4127).
4. If the problem persists, contact the Ingeteam Technical Service.
8
Firmware update
ABI2012IQM02_ - User manual