Identification And Servicing - Grillo GF3 Manuel D'utilisation

3) Never have anyone check the machine while you are driving with the engine running.
4) The user is always responsible for injury or damage to third parties.
5) Misshapen or damaged hoes must always be replaced and never repaired.
6) Always use original Grillo spare parts.
7) Before starting any work with the machine, check that all the accident prevention systems with
which it is equipped are in perfect working order. They must never be disabled or tampered with.
8) Before starting work, check that the nuts and bolts securing the tools are perfectly tight.
9) All protective fittings (hoods, mudguards, etc.) must be kept in place during operation.
10) Never clean the implements with the engine running.
11) Never use the machine barefoot.
12) Never change the engine settings, especially the maximum r.p.m.
13) Allow the engine to cool before placing the machine indoors.
14) CAUTION: to reduce the risk of fire, keep the engine, the exhaust pipe and the exhaust
manifolds free from grass, leaves, dust, etc...
15) If you have to empty the fuel tank, do this outdoors.
16) This machine must be driven by one operator only.
IDENTIFICATION
The machine's serial number is placed on the
machine's frame.
Always state the serial number when ordering
spare parts or asking for technical assistance.
AFTER-SALES SERVICE
This handbook provides instructions for use of the machine and for correct basic servicing which
the user can carry out himself. For all procedures not described in this handbook, contact your
local dealer.
SPARE PARTS
Always use original spare parts, as they are the only ones to offer complete safety and
interchangeability. Always state the serial number when ordering. For engine parts, refer to the
specific handbook.
WE ADVISE YOU TO KEEP THE FOLLOWING SPARE PARTS TO HAND
No. 1 throttle cable
No. 1 clutch cable
No. 1 throttle lever
No. 1 clutch lever
For the mower bar:
No. 3 mower bar fingers
No. 10 nails
No. 1 complete blade
No. 2 blade couplings
ORDERING SPARE PARTS
Always state the machine serial number and the code number of the part to be replaced.
Contact your local dealer. Our address is:
GRILLO S.p.A.
Via Cervese 1701 - 47521 CESENA (FC) - ITALY
Tel. 0039 / 0547 / 633111 - Fax 0039 / 0547 / 632011
Web site: www.grillospa.it - E-mail: grillo@grillospa.it
GF3 – Translation of the Original Instructions

IDENTIFICATION AND SERVICING

5