iLine microsystems microINR link Instructions D'utilisation page 9

Important information regarding the correct use of the
system that does not affect the safety of the patient or the
integrity of the device is displayed over a blue background.
Infection Risk Control on Multi-Patient Test System
• Healthcare professionals must wear gloves during the entire
process of the test.
• A separate lancet or lancing device must be used for each
individual.
• Used Chips, lancets and gloves might be source of infection.
Dispose of them in accordance with local regulations to
prevent infections.
• Also, comply with your centre's internal hygiene and safety
regulations.
There is a potential risk of infection. Healthcare
professionals using the microINR system on multiple
patients must take into account that all objects that
come into contact with human blood are a possible
source of infection. (See: Clinical and Laboratory
Standards Institute: Protection of Laboratory Workers
from Occupationally Acquired Infections; Approved
Guideline, Fourth Edition CLSI document M29-A4, 2014).
Wireless Technology
The microINR Link Meter can communicate and transfer results
to a PC or other electronic device (e.g., computer, tablet or
smartphone) through a wireless Bluetooth connection.
Bluetooth is a form of radio frequency (RF) technology that
operates in the unlicensed industrial, scientific, and medical
band at 2.5 GHz. The microINR Link Meter can only
communicate with one compatible paired electronic device at
each time; therefore, other devices with Bluetooth cannot
access the information on the Meter unless the paired Meter is
first unpaired and paired to a new electronic device.
In case of electromagnetic interference with another device, it
is recommended to increase the distance between the Meter
and that device. You could also turn off the interfering device.
In addition, the Meter's Bluetooth wireless connection could be
turned off.
The device generates, uses, and can radiate radio frequency
energy.
Electromagnetic Compatibility and Electrical Safety
The microINR Link Meter system complies with
electromagnetic compatibility requirements according to IEC
61326-1 and 61326-2-6 standards.
Do not use the microINR Link Meter near sources
of intense electromagnetic radiation, as this could
interfere with its correct operation.
The microINR Link Meter complies with electrical safety
requirements according to standards IEC 61010-1 and IEC
61010-2-101.
The Meter must be disposed of as indicated in the WEEE
Directive (Waste Electrical and Electronic Equipment
2012/19/EU).
03