Publicité
Les langues disponibles
Les langues disponibles
Read the safety and all other instructions that come with the cutting stand.
PLEASE NOTE:
Failing to do so and disregarding the safety and all other instructions may cause injuries.
Keep these operating instructions for future reference in a safe place.
This cutting stand is an aid for cutting work (exclusively for metal) with a one-hand angle grinder.
It is suitable for use with most angle grinders with a disc size of Ø 180 or Ø 230 mm. Carefully read
this instruction manual and especially the safety instructions before using the cutting stand.
Warning of general danger.
Wear a dust mask.
Wear safety goggles.
Wear ear protection.
Wear protective gloves.
Read instructions/information.
• It is imperative that you adhere to the information in the
instruction manual for the angle grinder used. This device must correspond to the VDE standards.
Only devices with a CE symbol are to be used.
• Keep children away from the workplace and also keep the tools out of the reach of children.
• Always wear protective goggles, ear protection, protective gloves and a mouth or nose protection
respectively.
• Wear suitable working clothes; do not wear any wide clothing or jewellery as they could be caught
up in moving parts. Non-slip shoes are recommended. Wear a hair net if you have long hair.
• Before use, ensure that the device is correctly and securely mounted in the retainer.
• Never stop the cutting disc with the hands or other objects. Never reach into the working area of the
running cutting disc or touch the cutting disc during the work. There is a risk of injury!
• Fix the cutting stand on both of the mounting perforations to the base plate (1) on the workbench.
Ensure that the bench and the stand are securely positioned.
• Ensure that the workplace is clean and well illuminated.
• Always use the protective cover (22).
t
Introduction
Intended use
Symbols and meanings
Safety instructions
8
Pull out mains plug.
Do not use defective cutting discs.
Use for cutting only, not for roughing.
Exclusively for metal.
Secure workpiece between
the clamping jaws.
Secure cutting stand to a firm
base using suitable screws.
Use only Ø 180 mm and Ø 230 mm
cutting discs.
Publicité
