Oase Water Quintet Creative Notice D'emploi page 15

Intended use
Water Quintet Creative , in the following termed "unit", is a set composed of several water feature fountains with LED
lighting. The water feature fountains can be permanently installed or suspended in any desired arrangement.
The unit may only be operated in clean pond water at water temperatures between +4 °C and +35°C. This also applies
to all other components being part of our scope of delivery.
The unit may be operated in swimming ponds as well as in water basins on patios. Minimum distance from the edge:
1.5 m.
Mechanical installation
Setting up the Water Quintet Creative
Information about both installation variants (A, B, C):
To ensure flexible pump installation, the cables can be separated from the cable bundle by opening the cable protec-
tion jacket (A, 36). The following always applies:
• Minimum distance between pump and pond or basin rim: 1.5 m.
• Position the pumps such that they are fully submerged in the water at all times.
• Ensure that the water supply at the pump filter basket is unobstructed (8).
Variant 1 - Firm installation in the ground (C):
• Place the pumps horizontally on a firm ground in the water.
• For larger water depths, screw-connect the extension tubes (6) between the LED light nozzles (10) and the
pumps (12) to equalise differences in height. If this is not practical, select a different place of installation. A maximum
of two extension tubes per pump can be used.
• To prevent floating up, load the pump base with rocks or bolt the pump onto a plate.
Variant 2 - Suspended installation (D):
• Unscrew the nozzle holder (9).
• To suspend the unit, screw one of the supplied extension tubes or both (6) between the LED light nozzle (10) and the
pump (12).
• Hook the pumps in a suitable suspension plate (11). Either allow the nozzle holder (9) to sit on the suspension plate
or insert it to be flush with the plate top face (D).
Control box and transformer installation
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Only operate the unit with the protection hood fitted.
• Ensure that the unit is installed in a flood protected position at a distance of at least 2 m from the water.
Install the 12 V control box at a place protected from sun radiation (max. 40 °C).
Variant 1 (E):
• Push the ground stake (5) fully into the ground at the desired position.
• Slide the 12 V control box (3) onto the ground stake (5).
Variant 2 (F):
• Screw the 12 V control box (3) to the ground using 4 screws (13) (not included in our scope of delivery) through the
fastening slots (14) in the housing of the 12 V control box (3).
Installation of the transformer (G):
Install the transformer (2) close to the 12 V control box (3).
Note: Ensure that the cables are routed strain relieved!
- EN -
15