Oase Water Quintet Creative Notice D'emploi page 16

- EN -
Electrical installation
N O T E
The unit will be destroyed if it is operated with a dimmer. It contains sensitive electrical components.
• Do not connect the unit to a dimmable power supply.
Connect the unit to the 12 V control box (G, H):
• Plug the pump plugs (18) as well as the LED light nozzle plugs (20) into the respective sockets for the pump (19) and
the LED light nozzles (21) of the 12 V control box (3). Note the order of the plugs (plugs are marked).
• Insert the connection cable (17) of the transformer in the rear socket (15) of the 12 V control box (3), then screw-
tighten the cable with the union nut (16).
• Fit the protection sleeve (4) over the 12 V control box (3).
Commissioning/start-up
Switching on the unit: Plug the power plug of the transformer into the socket. The unit will start with program 1 (see
chapter 'Control/Operation').
Switching off the unit: Disconnect the power plug of the transformer.
Operation
16
the manual transmitter (A, 7) can be used to select 9 programmed water feature patterns.
Program 1 appears automatically when starting up and with each new start of the unit.
P0 Unit off, stand-by mode
P1 All fountains active, fixed height up to max. 30 cm
Light on for all fountains
P2 All fountains active, fixed height up to max. 70 cm
Light on for all fountains
P3 All fountains active, dynamic fountain height, max. 70 cm high
Light on for all fountains
P4 One fountain each alternatingly active in intervals, max. 70 cm high
Light switched on for each active fountain
P5 All fountains active, fixed height up to max. 110 cm
Light on for all fountains
P6 All fountains active, dynamic fountain height, max. 110 cm high
Light on for all fountains
P7 One fountain each alternatingly active in intervals, max. 140 cm high
Light switched on for each active fountain
P8 All fountains active, dynamic fountain height, max. 140 cm high
Light on for all fountains
P9 Several fountains alternatingly active, max. 140 cm high
Light switched on for the respective active fountains
Select next program: Button 1
Select previous program: Button 2
Note:
− If the unit is switched by means of a timer, always program 1 is started.
− Fountain heights can be varied.