Water Tank & Drain Hose - INVENTOR R2-ION8L Manuel D'utilisateur

TIMER
Use the TIMER button to set unit OFF by 1/2/4/8 hours. The unit will switch off upon se-
lecting the desired time-frame.
IONIZER
Press "IONIZER" button to switch on or off the ionizer. By activating the ionizer, nega-
tive ions are released to purify the air and remove unpleasant and unhealthy particles.
WATER FULL
Indicator "Full Water Tank" turns on following a beep alert when bucket is full, removed, or
misplaced.
• The water level control switch shuts off the dehumidifier when the bucket is
full, removed or misplaced.
ALARM
If the unit malfunctions, an alarm system will activate and the unit will automatically
shut down.
Internal Over Heating Protection: During operation, malfunctions may occur if the
air intake or exhaust are obstructed or blocked by objects. This can cause high inter-
nal temperatures and the appliance will automatically shut down. Unplug the device
immediately and resume operation after 5 minutes.
Tipping Protection: The unit has a heater inside, to avoid overheating, the unit is
equipped with a tipping switch that automatically shuts down the device in the event
the unit tips over.
8. WATER TANK & DRAIN HOSE
There are two ways to remove collected water. Before proceeding, ensure that you
have switched off and unplugged the device.
1. Using the water bucket
When the water tank is full, the alarm will beep and the Water Full indicator light will
turn on.
• Slowly remove the bucket. Grip the handle with caution, and carefully pull outwards
so the water does not overflow. Do not place the tank on the floor because the bot-
tom of the tank is uneven. Doing so the tank will fall and the water will be spilled on
the floor.
• Empty the water from the tank and place it again in to the device. The water tank,
must be securely and properly placed, for the dehumidifier to operate.
• When the water tank is re-installed the unit will automatically restart.
12
EN