Publicité
Les langues disponibles
Les langues disponibles
Please unfold page 3. Then you can always see the
operating elements and connections de scribed.
1 Operating Elements and Connections
1 Transmitting antenna
2 Power switch
3 Indication of the transmission group and the trans-
mission channel (also see table fig. 3 on page 8)
4 Microphone connection (4-pole mini XLR jack)
5 Key
for scanning the transmission group/chan -
nel in ascending order (in the group adjusting
mode/channel adjusting mode) and for activating
the locking function (in the lock adjusting mode)
6 Key
for scanning the transmission group/chan -
nel in descending order (in the group adjusting
mode/channel adjusting mode) and for deacti -
vating the locking function (in the lock adjusting
mode)
7 Indication of the battery status
8 Key SET
with the unit not locked:
to recall and to exit the adjusting modes for the
transmission group/channel, locking function
→ chapters 5.1 and 5.2.1
with the unit locked:
to recall and to exit the adjusting mode for the
locking function → chapter 5.2.2
9 Gain control; for matching the input sensitivity turn
the control with the adjusting key supplied
10 Battery compartment for two 1.5 V batteries of size
AA (R6)
11 Cover of the battery compartment
2 Important Notes
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient temperature
range 0 – 40 °C).
G
For cleaning only use a dry, soft cloth; never use
chemicals or water.
G
No guarantee claims for the unit and no liability for
any resulting personal damage or material damage
will be accepted if the unit is used for other purposes
than originally intended, if it is not correctly operated
or not repaired in an expert way.
If the unit is to be put out of operation defini -
tively, take it to a local recycling plant for a
disposal which is not harmful to the environ-
ment.
Dead batteries or defective rechargeable batteries
do not belong in the household rubbish; always take
them to a special waste disposal (e. g. collecting con-
tainer at your retailer).
3 Applications
Together with the multifrequency receiver US-903DC -
PRO from JTS this multifrequency pocket transmitter
makes up a wireless audio transmission system. The
transmitter operates with four transmission groups (A –
D) to which 16 transmission channels are assigned
respectively, i. e. altogether 64 factory-set transmission
channels are available. These channels in the UHF
range of 790 – 814 MHz can be selected as desired.
The pocket transmitter is supplied with the Lavalier
microphone CM-501. Instead of the CM-501 it is also
possible to use e. g. the headband microphones
CM-204... and CX-504 or the instrument microphones
CX-508W and CX-516W from the JTS product range.
3.1 Conformity and approval of the transmitter
Herewith, MONACOR INTERNATIONAL declare that
the unit PT-920BG is in accordance with the basic re -
quirements and the other relevant regulations of the
directive 1995/5/EC. The declaration of conformity
can be found in the Internet via the JTS home page
(www.jts-germany.de).
0197
.
!
This unit may be operated in the following countries:
DE
The regulations of the country where this unit is oper -
ated must always be observed. These regulations can
be found via links to the national authorities from the
following Internet address:
www.ec.europa.eu/enterprise/rtte/weblinks.htm
4 Power Supply
G
Only insert batteries of the same type and always
replace all batteries.
G
If the unit is not used for a longer period (e. g. more
than a week), remove the batteries. Thus, the unit
will not be damaged in case of battery leakage.
1) Open the Velcro fastener and take the transmitter
out of the belt bag.
®
The
approval
number
is
7
Publicité
