Meister BWS 500 C Traduction Du Manuel D'utilisation Original page 58

5405010-Winkelschl-man 23.01.14 10:45 Seite 58
edges or when it bounces. This will
lead to a loss of control or kickback.
e Do not use a chain or toothed saw
blade. Such tools often cause kick
back or the loss of control of the
electrical tool.
Particular safety notes with regard to
sanding and abrasive cutting:
a Use only grinding tools expressly
permitted for use with your
electrical tool and the appropriate
protective hood for these grinding
tools. Grinding tools which are not
designed for use with the electrical
tool cannot be properly shielded and
are unsafe.
b The protective hood must be affixed
securely to the electrical tool and set
in such a way that it ensures the
maximum level of safety possible,
i.e. the smallest possible area of the
grinding tool is exposed to the
operator. The protective hood should
protect the operator from broken
pieces and accidental contact with the
grinding tool.
c Grinding tools may only be used for
the recommended applications. For
example: Never sand using the side
surface of a cutting wheel. Cutting
wheels are designed to remove
material with the edge of the disc.
Lateral forces working on these
grinding tools may break them.
d Always use undamaged tensioning
flanges in the correct size and
shape for the sanding disc you
have selected. Suitable flanges
support the sanding disc and thus
reduce the danger of the disc
breaking. Flanges for cutting wheels
58
may differ from flanges for other
sanding discs.
e Do not use worn sanding discs from
larger electrical tools. Sanding discs
for larger electrical tools are not
designed to handle the higher
revolutions of smaller tools and may
break.
Additional safety notes with regard to
abrasive cutting:
a Avoid blocking the cutting wheel or
employing too great a pressure. Do
not execute any excessively deep
cuts. Overloading the cutting wheel
increases the wear and the tendency to
tilt or block and thus the possibility of
kick back or breaking of the grinding
tool.
b Avoid the area in front and behind
the rotating cutting wheel. If you
move the cutting wheel away from
you within the tool, in the event of the
electrical tool kicking back, the
turning wheel may be thrown in your
direction.
c If the cutting wheel blocks or you
stop working, switch the unit off
and hold it still until the wheel has
come to a standstill. Never attempt
to pull a running cutting wheel out
of the cut, this may cause kick
back. Work out and eliminate the
cause of the blockage.
d Do not switch the electrical tool
back on with it still in the
workpiece. Wait until the cutting
wheel has reached the full
revolutions before you carefully
continue with the cut. Otherwise the
wheel may get caught, jump out of
the workpiece or cause kick back.