Domo DO462FR Mode D'emploi page 38

DO462FR
the basket and release the 2 ends. Place the handle in a
horizontal position until it clicks.
5. Fill the oil container with liquid oil, suitable for heating,
until the oil level is situated between the "MIN" and
"MAX" level indicated in the oil container. Don't ever use
the appliance when there is too much or too little oil in
the container.
6. Place the basket back into the container.
7. Place the plug in the outlet. The red light will light up.
8. Switch on the appliance by turning the temperature knob.
9. Select the desired temperature with the temperature knob.
The oil will start to heat up. The green light will go on when
the desired tempeature is reached. The deep fryer is now ready for use. When the
temperature of the oil drops, the temperature indicator light will go out and will
go on again when the desired temperature is reached again.
10. Place the basket with the support onto the edge of the fryer and place the food you
wish to fry in the basket. For an optimal baking result, only fill half of the basket.
Carefully place the basket back into the oil.
Note: to preserve the quality of the oil, it is recommended to spice up the food
after frying.
11. Remove the basket from the oil and check if the food is thoroughly cooked.
12. Let the food drip for 10 to 12 seconds.
AFTER USE
1. Turn the temperature knob to the minimum.
2. Remove the plug from the outlet.
3. Place the basket back in the oil container.
4. Close the lid.
5. Wait for the deep fryer to cool down completely before storing it.
CLEANING THE APPLIANCE
Switch off and unplug the appliance before cleaning it.
CLEANING OF THE OUTSIDE OF THE APPLIANCE
Clean the outside of the deep fryer after every use with a damp cloth, soaked in a bit
of soapy water. The control panel cannot be put in water or any other liquid.
38