Maintenance - Tanaka TCG 24EBSP SL Mode D'emploi

English
6. Check that the cutting attachment does not rotate
when the engine is idling.
Cutting (Fig. 17, 18, 19)
○ When cutting, operate engine at over 6,500 min
Extended time of use at low rpm may wear out
the clutch prematurely.
○ Cut grass from right to left.
○ Wear the harness as shown in the fi gure (if so
equipped). The cutting attachment turns counter-
clockwise, therefore, be advised to operate the
unit from right to left for effi cient cutting. Keep
onlookers out of working area at least 50 ft
(15 m).
○ Please use the unit/machine in accordance with
state and local legislation.
50 ft
(15 m)
12
Fig. 17
Fig. 18
Fig. 19
WARNING
If cutting attachment should strike against
stones or other debris, stop the engine and
make sure that the attachment and related
.
-1 parts are undamaged. When grass or vines
wrap around attachment, stop engine and
attachment and remove them.
Stopping (Fig. 20)
Decrease engine speed and run at an idle for a few
minutes, then turn off ignition switch (16).
WARNING
A cutting attachment can injure while it
continues to spin after the engine is stopped
or power control is released. When the unit is
turned off , make sure the cutting attachment
has stopped before the unit is set down.
Semi-auto cutting head
○ When cutting, operate engine at over 6,500 min
Extended time of use at low rpm may wear out
the clutch prematurely.
○ Cut grass from right to left.
WARNING
A cutting attachment can injure while it
continues to spin after the engine is stopped
or power control is released. When the unit is
turned off , make sure the cutting attachment
has stopped before the unit is set down.
Automatically feeds more nylon cutting line when it
is tapped at low rpm (not greater than 4,500 min

MAINTENANCE

MAINTENANCE, REPLACEMENT OR REPAIR
OF THE EMISSION CONTROL DEVICES AND
SYSTEMS MAY BE PERFORMED BY ANY NON-
ROAD ENGINE REPAIR ESTABLISHMENT OR
INDIVIDUAL.
16
Fig. 20
.
-1
).
-1