Ryobi RCS1400 Traduction Des Instructions Originales page 6

MAINTENANCE
WARNING
The product should never be connected to a power
supply when assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
accidental starting that could cause serious injury.
When servicing, use only original Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
Be sure to disconnect the product from the power supply
before attaching or removing the saw blade. Clean the
product and guarding system with clean cloths.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Do not, at any time, let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
If the power supply cord is damaged, it must be
replaced only by the manufacturer or by an authorised
service centre to avoid risk. Contact authorised service
centre.
For greater safety and reliability, all repairs should be
performed by an authorised Ryobi service centre.
LUBRICATION
All of the bearings in the product are lubricated with a
sufÞ cient amount of high grade lubricant for the life span of
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety alert
V Volts
Hz Hertz
Alternating current
W Watts
n
No-load speed
o
min ¹ Revolutions or reciprocations per minute
4 | English
Class II tool, double insulation
Wood
Do not cut metals
Wear ear protection
Wear eye protection
Laser radiation.
Do not stare into beam.
Class 2 laser product
: 650nm; P 1mW
EN 60825-1:2014
Danger! Sharp blade
Do not expose to rain
Width of cut
Blade teeth
CE conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Please read the instructions carefully before
starting the machine.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authority or retailer for recycling
advice.
SYMBOLS IN THIS MANUAL
Connect to the power supply.
Disconnect from the power supply.
Parts or accessories sold separately