Mapping - Fermax CITYLINE VDS-BUS2 Manuel D'installation

VDS-BUS2 Programming
VDS-BUS2 Programming

Mapping

Examples of possible assignments using the mapping functions:
42
41
31 32
21 22
11 12
Floor/Residence
Very useful in systems with
general MDS entrances
When mapping is carried out, the amplifi er saves the link between the natural call
code (address) and the newly assigned call code in a table.
Mapping
There are 2 ways of carrying out mapping:
1. Inverse Programming (Only possible inf there are monitors at each
apartment. 2 operator requiered)
This method is inverse to the current one. Following steps:
1. Programme the monitor locally and independently via an entry panel
or guard units with a keypad. (The iLOFT and Compact monitors allow
programming via the monitor itself).
2. Select the «inverse button programming» mode on the amplifi er:
Press the SW1 button (a characteristic 2«beep» tone will be emitted
from the speakers).
14
13
10
9
6
5
1 2
With double panels: call assignment
based on the distribution of residences
by fl oor
BUILDING
PAZ
C/ la Paz, 7
16
15
12
11
8
7
3 4
Pag 11