Reely SKY RC Mini E C-17E Mode D'emploi page 14

Table des Matières

Les langues disponibles

1. Apply the supplied glue in a thin layer on the back of the fuselage. Now fit the height rudder

precisely to the fuselage and press the height rudder down slightly.

2. Now apply a thin layer of glue to the vertical rudder and then place the vertical rudder on the top of the heigt rudder and fuselage. Ensure that the

vertical rudder is placed in an angular position to the height rudder. The vertical rudder is controlled via the remote control (right control stick).

The panning range of the vertical rudder can be changed accordingly by adjusting the joint or adjusted by turning.

Vertical rudder

Now allow the glue to go hard so that the veritcal rudder and height rudder cannot slip and

are firmly placed on the fuselage.

3. Then remove the double-sided adhesive tape from the wing bar which you subsequently

press the two wing halves to.

4. Now press the individual wing halves firmly onto the wing bar.

• Ensure the correct angular position of the wing bars.

• Also ensure a precise fit between the wing bar and wing halves.

• If you remove the wing halves again, they are damaged by the adhesive tape. In addition,

the adhesive force of the adhesive tape is not sufficient to fit the wing stably on the wing bar

if they are stuck on a second time after being removed.