Installation; Start-Up; Temperature Control - AYA CC2003A+ Manuel D'utilisation

INSTALLATION

This refrigerating appliance is not intended to be used
as a built-in appliance.
Fully unpack the appliance. Please ensure that all packaging
materials are removed and properly disposed prior to
installation and kept out of children's reach.
The appliance should be installed in a dry, well ventilated room,
and not exposed to direct sunlight and not placed near a heat
source.
Leave at least 30cm between the appliance and surrounding for
ventilation and heat dissipation.
The electricity supply must conform to as specified on the rating
plate and follow local regulations.
It is recommended to wait at least two hours before plugging the
appliance after installation. This helps the refrigerant circuit to
stabilize.

START-UP

1. Insert the plug in the socket. The green light on the control
panel goes on.
2. Allow one hour for the temperature inside the appliance to go
down and the place food inside the appliance.

TEMPERATURE CONTROL

The temperature can be regulated in different positions.
Position ''0'' means equipment on STOP mode. Position '' 7''
means equipment operation at maximum.
Remember that thermostat settings are affected by variations in
ambient temperature, the quantity of food stored, the position
-29-