General Cleaning And Tightening; Storage - Maruyama M42BK-QC Manuel Du Propriétaire

General Cleaning and Tightening

WARNING
POTENTIAL HAZARD
• When engine is running, Attached
Tool is rotating/ moving and other
parts are moving.
WHAT CAN HAPPEN
• Contact with rotating/moving Tool
or other moving parts could cause
serious personal injury or death.
HOW TO AVOID THE HAZARD
• Always turn off your Multi-Cutter
before you clean or perform any
maintenance on it.
The MARUYAMA Multi-Cutter will provide maxi-
mum performance for many, many hours if it is main-
tained properly. Good maintenance includes regular
checking of all fasteners for correct tightness, and
cleaning the entire machine.

Storage

For long term storage of the Multi-Cutter:
1. Empty the fuel tank into a suitable fuel storage
container.
2. Pump the primer bulb on the carburetor until all
fuel is discharged through the clear fuel return
hose.
3. Run the engine to remove any fuel that may
remain in the carburetor.
4. Perform all regular maintenance procedures and
any needed repairs.
5. Remove the spark plug and squirt a very small
amount of oil into the cylinder.
POTENTIAL HAZARD
• Oil may squirt out of the spark plug
opening when you pull the starter grip.
WHAT CAN HAPPEN
• Oil can cause eye injuries.
HOW TO AVOID THE HAZARD
• Protect your eyes and keep your face
away from the spark plug opening.
6. Pull the starter grip once.
7. Slowly pull the starter grip to bring the piston to
the top of the cylinder (TDC).
8. Reinstall the spark plug.
9. Store the Multi-Cutter in a dry place away from
excessive heat, sparks or open flame.
— US-24 —
CAUTION