Starting And Stopping - Maruyama M42BK-QC Manuel Du Propriétaire

4. Pour the correct amount of oil into the container
then add the remaining amount of gasoline.
5. Close the container tightly and shake it momentar-
ily to evenly mix the oil and the gasoline before
filling the fuel tank on the Multi - Cutter.
6. When refilling the Multi - Cutter fuel tank, clean
around the fuel tank cap to prevent dirt and debris
from entering the tank during cap removal.
7. Always shake the premix fuel container momen-
tarily before filling the fuel tank.
8. Always use a spout or funnel when fueling
to reduce fuel spillage.
9. Fill the tank only to within 1/4-1/2 in. (6 mm-13
mm) from the top of the tank. Avoid filling to the
top of the tank filler neck.

Starting And Stopping

Before Starting The Engine
1. Fill the fuel tank as instructed in the Before
Operation section of this manual (page US-16).
2. Rest the Multi-Cutter on the ground.
3. Make sure the cutting attachment is clear of any
broken glass, nails, wire, rocks or other debris.
4. Keep all bystanders, children and animals away
from the working area.
Cold Starting Procedure
This Multi-Cutter is equipped with a fuel primer and a
choke system. To start a "cold" engine properly, per-
form the following procedure:
1. Pump the primer bulb at the bottom of the carbu-
retor until fuel can be seen flowing through the
fuel return line to the fuel tank.
(Flowing fuel should be almost clear, not foamy or
full of bubbles.)
Fuel Return Line
2.
3.
Choke Lever
Fast-idle Start Lock
4.
Primer Bulb
— US-18 —
Move the choke lever to the closed (
and move the stop switch to the "ON" position.
Lock the throttle trigger in the fast-idle start posi-
tion, then pull the starter grip.
STOP (OFF)
Stop Switch
CAUTION
• Do not pull the Starter rope all the way
out.
WARNING
• Do not disassemble the Starter. Please
ask for an authorized MARYAMA ser-
vice dealer.
After the engine starts, squeeze and release the
throttle trigger to return it to the idle position, then
move the choke lever to the open (
If the engine stops running before you move the
choke lever to the open (
Go ahead and open the choke, pull the starter grip
with the throttle trigger positioned at Fast-idle
position
) position
Starter Grip
START (ON)
Fast-idle Start
Position
Idle Position
) position.
) position: