Connecting Throttle Cable; Cable Adjustment - Maruyama M42BK-QC Manuel Du Propriétaire

Connecting Throttle Cable

1. Loosen the knob and remove the air filter cover,
insert the throttle cable through the cable adjuster
sleeve on the carburetor bracket. Make sure the
end of the cable housing is seated positively in the
sleeve.
2. Position the slotted fitting on the carburetor so the
recessed hole for the cable lug is away from the
cable adjuster sleeve.
Cable Adjuster Sleeve
Throttle Cable Housing
Carburetor Bracket
Cable Adjuster
Sleeve
Carburetor Throttle Cam
Slotted Fitting
3. Rotate the carburetor throttle cam clockwise and
slip the throttle cable through the slot in the slot-
ted fitting, making sure the cable lug drops into
the recessed hole.
4. Operate the throttle trigger a few times to make
sure that it works correctly.
5. Lap and fix the stop switch wires and connectors
with clamp.
Locknut
Throttle Cable
Slotted Fitting
Recessed
Hole
Throttle Stop/Idle Speed
Adjuster Screw Bracket
Idle Speed
Adjuster Screw
6. Bind the throttle cable and the flexible shaft with
four bands.
Throttle Cable
Cable
Lug
Band

Cable Adjustment

• Throttle cable should be paralleled to flexible
shaft. In case of twisting, they should be restored
by parallel.
• Throttle cable should be adjusted under the bend-
ed flexible shaft as shown.
1. Adjust the cable adjuster sleeve so the stop on the
carburetor throttle cam just contacts the throttle
stop and the cable position keep 1-2mm play
between cable lug and slotted fittings when the
throttle trigger is fully depressed.
Flexible Shaft
2. When the throttle cable is adjusted correctly, tight-
en the lock nut.
— US-14 —
Flexible Shaft
Throttle Cable
Clamp
Band
1-2mm Play