Assembling Engine And Drive Shaft Assembly; Connecting Stop Switch Wires; Connecting Throttle Cable - Maruyama EH23DSL Manuel Du Propriétaire/De L'utilisateur

Assembly

Assembling Engine and Drive Shaft Assembly

Attach the clutch drum housing to the engine using the four screws
supplied with the unit.

Connecting Stop Switch Wires

1. Install the plastic tube (packed with the driveshaft assembly) around
the throttle cable and stop switch wires.
2. Loosen the knob and remove the air filter cover to access the stop
switch wires.
3. Plug the stop switch wires into the matching connectors from the
engine. Note that wire polarity is not important.

Connecting Throttle Cable

1. With the air filter cover removed, insert the throttle cable through the
cable adjuster sleeve on the carburetor bracket. Make sure the end
of the cable housing is seated positively in the sleeve.
2. Position the slotted fitting on the carburetor so the recessed hole for
the lug is away from the cable adjuster sleeve.
3. Rotate the carburetor throttle cam and slip the throttle cable through
the slot in the slotted fitting, making sure the cable lug drops into the
recessed hole.
4. Operate the throttle trigger a few times to make sure that it works
correctly.
5. Adjust the cable adjuster sleeve so the stop on the carburetor
throttle cam just contacts the throttle stop and the cable position
keep 1-2mm play between cable lug and slotted fittings when the
throttle trigger is fully depressed.
− US-13 −
Engine
Screw (4)
Clutch Drum Housing
Shaft Grip Plastic Tube
Stop Switch Wires
Throttle Cable
Matching Connectors
Stop Switch Wires
Throttle Cable Housing
Cable Adjuster Sleeve
Lock Nut
Throttle Cable
Slotted Fitting
Carburetor
Bracket
Recessed Hole
Knob
Air Filter
Cover
Matching
Connectors
Cable Lug