Corghi ERCO 500 Manuel D'utilisation page 62

6.6 RISK OF THE VEHICLE FALLING FROM THE LIFT
Vehicle falling from the lift can be caused when the vehicle is improperly placed on platforms, and
when its dimensions are incompatible with the lift or by excessive movement of the vehicle.
In this case, keep immediately away from the working area.
Fig. 11a
6.7 SLIPPING RISKS
The risk of slipping can be caused by oil or dirt on the floor near
the lift.
Keep the area under and around the lift clean. Remove all oil spills.
6.8 ELECTROCUTION RISKS
Avoid use of water, steam, solvent, varnish jets in the lift area where electric cables are placed and, in
particular, next to the electric panel.
6.9 RISKS RESULTING FROM IMPROPER LIGHTING
Make sure all areas next to the lift are well and uniformly lit, according to local regulations.
6.10 RISKS OF BREAKING COMPONENT DURING OPERATION
Materials and procedures, suitable for the designed parameters of the lift,
have been used by the manufacturer to build a safe and reliable product.
Operate the lift only for the use it has been designed for and follow the
maintenance schedule shown in the chapter "Maintenance".
62
Fig. 11b
Fig. 11c
Fig. 12
Fig. 13