Klarstein 10030518 Mode D'emploi page 9

• Switch off power supply for blender and pull out plug;
• After use, the parts must be cleaned in time;
• Never immerse the machine (power unit) in water or any other liquid, nor flush under faucet. Clean the ma-
chine with wet cloth;
• The product should be stored in a dry place, avoid direct exposure to ultraviolet rays.
• Before storing the product, make sure that the product is clean and dry.
Problem
Unable to work
Abnormal smell comes from motor unit
during operation
Knife blade device or motor unit is stuck
during operation
Stirring cup subject to leakage
Should boiling hot raw material be poured
into stirring cup?
According to the European waste regulation 2002/96/EG this symbol on the product
or on its packaging indicates that this product may not be treated as household waste.
Instead it should be taken to the appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product. For more de-
tailled information about recycling of this product, please contact your local council or your
household waste disposial service.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European Directives:
2004/108/EC (EMC)
2011/65/EU (RoHS)
2006/95/EC (LVD)
9
Cleaning and Care
Troubleshooting
Possible Cause and Solution
Check if power plug is inserted and stirring cup is correctly installed.
For the first several operations, it is normal for a new product to cause some
abnormal smell or smoke, and the phenomenon would disappear after
several operations. In addition, the product working for a long time conti-
nuously would also cause abnormal smell or smoke, shut down the product
and cool it down 60min.
Power off, move away the cup and scrap raw material on blade with spatula,
and small processing quantity should be added each time.
Power off, move away the cup and pour out raw material, unscrew antic-
lockwise the blade unit for mixing. Check if sealing ring is correctly installed
on the mixing blade holder.
No, to prevent accessory damage, it is required to allow the liquid or raw
material cool down to Celsius 60 degrees.
Hints on Disposal
Declaration of Conformity