Stadler Form Albert little Mode D'emploi page 12

• Do not immerse the dehumidifier into water or any other liquids and do
not pour water or any other liquids onto the appliance or into the air intake
and air outflow vents.
• Clean the dehumidifier regularly, following the cleaning instructions.
• Always transport the dehumidifier in an upright position. Before using
the dehumidifier for the first time, leave it standing in an upright position
for 24 hours. Always stand the dehumidifier in an upright position imme-
diately after transporting the appliance, and wait for at least 60 minutes
before switching it back on. The water tank must be emptied every time
before transport.
• The dehumidifier must always be operated according to this instruction
manual. Non-observance of these instructions can lead to injuries, a fire,
electric shock or faults in the appliance.
• The dehumidifier is designed for private use indoors and is not intended
for commercial use.
• Do not use the dehumidifier if it is faulty or could show signs of damage,
or if it is not functioning correctly. Disconnect the plug from the power
socket.
• The appliance shall be installed in accordance with national wiring regu-
lations.
Setup / operation
1. Place Albert little on a flat surface in the desired area. Plug the power
cable (13) into an electric socket.
2. Press the on/off switch (3) to turn on the dehumidifier.
3. You can select the speed of the fan in the dehumidifier by pushing
the speed level selector (5). There are 2 speed levels. If the speed is
higher, the dehumidifying performance also increases.
4. With the hygrostat (4) the desired humidity level can be set (Con =
continuos). A humidity level not higher than 60% is suggested in
general. If the dehumidifier reached the selected humidity it will turn
off and after that check the humidity level in constant intervals by
turning on the fan for a short time.
5. The swing mode (6) allows to optimally distribute the dry air in the
room. This mode is also suitable for example to dry clothes fast and
efficient.
6. If you find the display and LED too bright (in a bedroom for example),
you may reduce the light intensity by pressing the night mode (7).
7. Once the water tank is full, the blinking symbol will appear on the
display and the dehumidifier turns off automatically. Please empty the
tank. Once you put back the tank, the unit will automatically restart.
8. Defrost function: If the temperature in the room is below 5°C, the
dehumidifier automatically runs in defrost mode. This mode is shown
on the display and frost build up in the unit will be avoided during
dehumidification. This function will be activated every 25 minutes for
a duration of 7 minutes.
9. If desired, it is possible to connect a drainage hose to the unit for
permanent water drainage. In this case connect the hose (14) to the
unit through the hole in the back of the dehumidifier and place the
end of the drainage in a water outlet. Please make sure the end of the
hose is lower than the spout, otherwise the water will not drain and
flooding may occur.