Hilti DX 35 Mode D'emploi page 33

Fault
A cartridge detaches itself from
the cartridge strip.
en
The piston gets stuck in the
base material / fastener is
driven too deeply.
The fastener is not driven
deeply enough.
The nail bends.
28
Possible cause
The fastener driving rate is too high.
The fastener is too short.
The fastener has no washer.
Driving power is too high.
The fastener is too long.
Driving power is too low.
Hard surface (steel, concrete)
Hard and/or large aggregates in the
concrete.
A rebar is located just below the con-
crete surface.
Remedy
Stop using the tool immediately.
Remove the cartridge strip and allow
the tool to cool.
WARNING
Do not attempt to forcibly remove
cartridges from the magazine strip or
tool.
Clean the tool and remove any loose
cartridges.
If the tool cannot be disassembled
contact your local Hilti Center.
Use a longer fastener.
Use a fastener with washer for applic-
ations on wood.
Use a less powerful cartridge.
Use a shorter fastener.
NOTE
Observe the min. fastener driving
depth requirements. Obtain a copy
of the Fastening Technology Manual
from your local Hilti Center.
Use a more powerful cartridge.
Use a more powerful cartridge.
NOTE
The DX 35 has no power regulation.
Use a more powerful cartridge.
If necessary, use a more powerful tool
and nails with a higher application
limit (e.g. DX 460 with X-U nails).
Use a shorter nail.
Use a nail with a higher application
limit.