PDS 7000 ET ETC Série Manuel De L'utilisateur page 62

a. Press the touch «Mode» for select the «Timer» mode.
b. Press the touch «Set», to set the time of removal, once your time chooses,
press the «Mode» key to select it.
c. Press the touch «Exit» to save your program.
3. The «Cycle»
The «Cycle» mode allows you to make programmed deposits spaced a programmed
time. It is a succession of doses.
a. Press the touch «Mode» for select the mode «Cycle».
b. To select the desired time interval between each removal, press the «Set»
key, once your time has been chosen, press the «Mode» key to select it.
c. Press the touch «Exit» to save your program.
4. The «Program»
a. Press the touch «Mode» for select the mode «Program».
b. Press the «Set» button to select your program, you can save up to 39
programs.
c. Press "Shot" to confirm the unit digits and then "Set" to select the tens digit.
Once the program is displayed, confirm with "Mode".
d. Select the desired program number. The data of the modes
«Timer and cycle» will be automatically saved in this program.
e. You can select other programs and record new data for timer and cycle
modes.
+ The touch «Teach»
This key is used to program or teach a removal time.
a. Press the «Mode» key to select the «Timer» mode.
b. Then press the «Teach» button, the led must be lit.
c. Press and hold the foot control or finger control to teach the desired removal
(the display will continue to flash).
d. When you are finished, press the «Teach» key to save your data.
NB : The on-screen time will be added (while blinking) each time the foot-switch or
finger control is initialized until the «Teach» key is pressed to lock the settings. Time
can be added to the current duration without having to erase and return to zero.
As long as the button flashes.
62
mode :
mode :
: