Operation - Panasonic EY7430 Instructions D'utilisation

CAUTION:
EN
If the collar does not return to its original
position or the bit comes out when
pulled on, the bit has not been properly
attached. Make sure the bit is properly
attached before use.
Use 6.35 mm hexagonal bits.
To ensure proper securement of the bit, use
only hexagonal bits with 9.5 mm detent.
6.35 mm
Model No: EY7430 & EY7530
III. OPERATION
[Main Body]
CAUTION:
• When operating the tool by
pulling the trigger, there may be
a momentary lag before rotation
starts. This does not signal a
malfunction.
* This lag occurs as the tool's
circuitry starts up when the
trigger is pulled for the first time
after installing a new battery
pack or after the tool has not
been used for at least 1 minute.
Rotation will start without any lag
during second and subsequent
operations.
• To prevent excessive temperature
increase of the tool surface, do
not operate the tool continuously
using two or more battery packs.
The tool needs cool-off time before
switching to another pack.
• Do not close up vent holes on the
sides of the body during operation.
Otherwise, the machine function
is adversely affected to cause a
failure.
• Do NOT strain the tool (motor).
This may cause damage to the
unit.
• Do not strain the motor.
• Use the tool in such a way as to
prevent the air from the body vent
holes from blowing directly onto
your skin. Otherwise, you may get
burned.
• During operation, keep all body
EY7530_7430_3732_0L32_02(Eng).indd
9.5 mm
- 10 -
10
parts away from the chuck and
any shavings. There is a risk of
injury resulting from being hit by
shavings or a broken or detached
drill bits. Replace all drill bits
regularly.
• Please interrupt the operation
when the body heats up, and after
let it cool down to the adequate
temperature before restarting.
NOTE
• Do not attempt to remove a screw
that is rusty or stuck using a box
driver (M6 or higher).
NOTE for EY7430
When drilling holes in metal
• Reduce pressure slightly just before
drilling through to the other side.
When drilling a hole more than 8mm
in diameter, start by drilling with
smaller bits and expand the hole with
larger bits until you reach the desired
diameter. If it encounters too much
resistance, the tool will lock or the bit
will slip inside the chuck.
• If the drill slips, remove and re-insert
the drill bit, then fasten the chuck
securely. Next, continue drilling, putting
only light pressure on the tool. When
drilling through metal, pressing hard
does not necessarily ensure that the
job will be done faster.
• Apply machine oil to the drill point to
make the job go more smoothly.
• Do not strain the motor.
• When the tool becomes very hot, stop
working temporarily and let it cool
down to avoid damaging it.
NOTE for EY7530
• Do not use for drilling holes in metal.
Under high torque, drill bits for metal
can chip and cause injury.
2014/08/18 15:40:52