Lexmark C500n Guide De L'utilisateur page 80

Avis relatif aux émissions électroniques
Remarque : afin de garantir la conformité aux normes de la FCC ainsi qu'aux autres normes relatives aux
interférences électromagnétiques du matériel informatique de la classe B, le câble réseau LAN
fourni avec l'imprimante doit être utilisé si une connexion LAN est installée. La non-utilisation d'un
câble réseau LAN peut entraîner la violation des normes de la FCC et d'autres normes relatives
aux émissions électromagnétiques.
Avis de conformité aux normes de la FCC (Federal Communications
Commission)
The Lexmark C500n printer base and network printer, Type 5023-110, has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
The FCC Class B limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult your point of purchase or service representative for additional suggestions.
The manufacturer is not responsible for any radio or television interference caused by using other than recommended cables or by
unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user's authority to
operate this equipment.
Remarque : To assure compliance with FCC regulations on electromagnetic interference for a Class B computing device, use a
properly shielded and grounded cable such as Lexmark part number 1329605 for parallel attach or 12A2405 for USB attach. Use of a
substitute cable not properly shielded and grounded may result in a violation of FCC regulations.
Any questions regarding this compliance information statement should be directed to:
Director of Lexmark Technology & Services
Lexmark International, Inc.
740 West New Circle Road
Lexington, KY 40550
(859) 232-3000
Industry Canada compliance statement
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Avis de conformité aux normes de l'industrie du Canada
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
Avis de conformité aux directives de la Communauté européenne (CE)
Ce produit est conforme aux exigences de sécurité des directives 89/336/CEE et 73/23/CEE du Conseil de la Communauté
européenne relatives au rapprochement et à l'harmonisation des législations des Etats membres en matière de compatibilité
électromagnétique et de sécurité des équipements électriques conçus pour une utilisation à puissance limitée.
Une déclaration de conformité à la Directive a été signée par le Directeur de la fabrication et du support technique, Lexmark
International, S.A., Boigny, France.
Ce produit satisfait aux limites de classe B EN 55022 et aux exigences de sécurité EN 60950.
Avis
Avis
80