Electric Power Table - Steel Cucine ZS7975 Manuel D'utilisation

Instructions for the installer
3.5.2 Type of power supply
3.5.3 Replacing the electric cable
To replace the electric cable, it is necessary to access the terminal board. It is located on the back
of the appliance, at the top left, as shown in the figure.
To replace the cable, proceed as follows:
open the terminal board box;
•
unscrew the screw A that locks the cable;
•
loosen the screw contacts and replace the cable
•
with one of the same length and conforming to
current regulations;
the "yellow-green" earth wire must be connected to
•
the terminal and must be approximately 20 mm
longer than the line cables;
the neutral "blue" wire must be connected to the
•
terminal marked with the letter N;
the line wire must be connected to the terminal
•
marked with the letter L.
3.6

Electric power table

OVEN
60 x 45
60x45 OVEN
ORIGINAL CONNECTION SET BY MANUFACTURER
.
TOTAL POWER
Max Watt
2100
37