Suntec Wellness KLIMATRONIC Heat Stream 2000 Slim Notice D'utilisation page 11

Operation
•
Operating voltage: 220-240V～, 50Hz, 2000W
•
Please connect the appliance to the power outlet and turn the appliance on at its back (Switch to I). The
appliance enters the standby mode. You can use the control panel on the device or the remote control
for further operations. Both have the same functions.
•
Control panel:
•
Press the on-/off-button on the control panel. Every button pressing is accompanied by a sound and
indicating lights. The appliance will operate with the following standards: Thermostat 22°C, low heating
level. If you press the on-/off-button again, the appliance will go back to the standby mode.
•
You can choose between two heating levels by pressing the heating level button: low heating level "LOW"
and high heating level "HIGH".
•
To adjust the heating temperature, press the thermostat button. The current active heating temperature
is indicated by the lights on the control panel. There are four temperatures and a continuous operation
mode preset in the appliance which can be chosen in the following order: 26°C, continuous operation
mode without indicating light, 14°C, 18°C, 22°C. In contrast to the adjustable heating temperatures, the
appliance will not turn off during the continuous operation mode when the environmental temperature is
higher than the set temperature.
•
When pressing the ventilation button, the heating will be paused. Previous settings regarding the heating
level will also be paused. Cool air is generated.
•
As soon as the environmental temperature is higher than the set heating temperature, the heating
function will turn off (exception: continuous operation mode). The ventilation function will also turn off
after 10 seconds. When the environmental temperature is 2°C lower than the set heating temperature,
the heating function will turn on again.
•
Please press the sensor function button to turn it on. During an active sensor function, the appliance will
turn off after 2 minutes if it cannot detect any motions and the indicating light next to the on-/off-button
will flash. If the appliance detects motions within 5 minutes, it will turn itself on again. The motion
detection sensor has a range of 1.8m and is influenced by the environmental temperature: the lower the
environmental temperature, the higher the sensor range and vice versa. The detection angle of the
sensor is vertically 60° and horizontally 90°.
•
To turn off the appliance, press the on-/off-button and then press the button on the back of the appliance
(switch to O). Please disconnect the appliance from the power outlet.
Cleaning
•
Always disconnect the appliance from the power outlet and let it cool before cleaning. Never immerse
the appliance and its electric components in water to prevent electric shocks.
•
Wipe over the exterior of the appliance with a soft cloth and a mixture of natural detergent and water
(below 50°C). Please let the appliance air dry.
•
Please do not use any chemicals or other abrasive cleaning solvents to clean.
•
There is a dust filter installed at the back of the appliance which can be cleaned separately with water.
Please only put the dust filter back inside the appliance when it is completely dry.
Sensor function
Thermostat
Ventilation
Heating level
On-/Off-button
Remote control: