Kubota K7563-99360 Manuel D'instructions page 21

7. Connect HYDRAULIC SUCTION HOSE to FITTING
(4601-10-10-NWO) with HOSE CLAMP. (Fig.44)
[Tightening torque: 4.0 to 5.0 N-m (0.41 to 0.51 kgf-m)]
(1) HYDRAULIC SUCTION HOSE <31>
(2) FITTING (4601-10-10-NWO) <37>
(3) HOSE CLAMP <44>
(4) PUMP
8. Clamp HYDRAULIC
HYDRAULIC SUCTION HOSE with a TIE CABLE.
(Fig.43 (6))
RETURN HOSE and
[11] Add SLEEVE to HOSE
1. Disconnect WATER OUT HOSE from ENGINE, and
cap the openings so that the coolant does not spill.
(Fig.45)
2. Remove HOSE CLAMP. (2)
(1) WATER OUT HOSE
(2) HOSE CLAMP
(3) FLANGE BOLT
(4) NUT
(5) HOSE CLAMP
(6) ENGINE
3. Pass WATER OUT HOSE through HOSE SLEEVE
and clamp both ends of it with TIE CABLEs. (Fig46)
4. Clamp WATER OUT HOSE to MAIN FRAME with
HOSE CLAMP.
5. Connect WATER OUT HOSE to ENGINE.
(1) WATER OUT HOSE
(2) HOSE SLEEVE <35>
(3) TIE CABLEs <64>
(4) HOSE CLAMP
FLANGE BOLT
NUT
(5) HOSE CLAMP
(6) ENGINE
21