Publicité
Les langues disponibles
Les langues disponibles
6. Mount the NEW AUXILIARY VALVE ASSY to rear
pipe of Mainframe and clamp with BRACKET CLAMP,
CLAMP CUSHION and four FLANGE BOLTs. (Fig.24)
[Tightening torque: 17.6 to 20.6 N-m (1.8 to 2.1 kgf-m)]
7. Connect the HYDRAULIC PRESSURE HOSE 2 to the
PUMP ASSY.
[Tightening torque: 35 to 41 N-m (3.6 to 4.5 kgf-m)]
(1) AUXILIARY VALVE ASSY <1>
(2) BRACKET CLAMP
(3) CLAMP CUSHION
(4) FLANGE BOLTs x 4
(5) HYDRAULIC PRESSURE HOSE 2
(6) PUMP ASSY
(7) Rear pipe of Mainframe
8. Install UPPER LEVER STAY 2 to left side of the
parking brake lever (Fig.25).
[Tightening torque: 17.6 to 20.6 N-m (1.8 to 2.1 kgf-m)]
9. Connect VALVE CABLE ASSY to the lever and set the
adjustment thread on cable to LOWER LEVER STAY.
(Taking in slack of VALVE CABLE ASSY)
10. Connect VALVE CABLE ASSY to VALVE ARM and
set the adjustment thread on cable. (Set them to the
notches in the middle of their adjusting thread)
(1) UPPER LEVER STAY 2 <7>
(2) LOWER LEVER STAY
(3) VALVE CABLE ASSY <2>
(4) CORD CLAMP <3>
(5) VALVE ARM
(6) JOINT PIN <4>
(7) PLAIN WASHER <5>
(8) SNAP PIN <6>
(9) FLANGE BOLTs
(10) PTO LEVER <15>
(11) LEVER GRIP <16>
(12) HEX. BOLT <8>
(13) FLANGE NUT <9>
15
Publicité
