HBM SLB-700A/06 Notice De Montage page 13

SLB-700A/06, SLB-700A/12
• Cover the transducer with a housing, if there is a chance that it may be in
an exposed location or there is a risk of mechanical damage. Make sure
that it is protected against condensation.
Fig. 5.1: Strain transducer installation
Load the transducer to its maximum capacity several times before calibration,
so that the mounting surface can settle. Then tighten the fastening bolts at the
nominal (rated) torque.
A2112-3.0 en/de/fr
Measurement object
13
HBM