Alarm Mode - Niko 350-34001 Manuel Technique

350-34001/350-34002/350-340X3/350-340X4/350-34902

4.7. Alarm mode

Parameter Description
Detection time frame This is the length of a monitoring window (if motion is detected during this time frame, it is considered positive).
# seconds
Amount of detected motion This is the number of subsequent frames with motion detections, that will trigger an alarm.
to trigger the alarm
#
Switch-off delay This is the length of a monitoring window (if no motion is detected during this time frame, it is considered negative).
# seconds
Amount of detected motion This is the number of subsequent frames with motion detections, that will trigger an alarm.
to disable the alarm
#
Behaviour when motion is This parameter defines the output value of the detector when motion is detected.
detected
Switch ON
Switch OFF
Do nothing
Behaviour after motion has This parameter defines the output value of the detector after motion has been detected.
been detected
Switch ON
Switch OFF
Do nothing
Repeat last command With this parameter, you can set the time period after which the last command needs to repeated.
every... (00:00:00=Disable)
hh:mm:ss
Lock mode With this parameter, you can enable a lock object to lock the channel.
Default value: Disable
Disable
Enable
8
EN
This is the time it takes for the detector to switch on after motion has been detected.
The alarm will switch on after the set number of positive motion frames have been detected.
This is the time it takes for the detector to switch off after motion has been detected.
The alarm will be disabled after the set number of positive motion frames have been detected.
When motion is detected, the detector sends a "1" to the output object.
When motion is detected, the detector sends a "0" to the output object.
When motion is detected, the detector sends nothing to the output object.
After motion has been detected, the detector sends a "1" to the output object.
After motion has been detected, the detector sends a "0" to the output object.
After motion has been detected, the detector sends nothing to the output object.
The detector will repeat the last command when the predefined time period has elapsed.
No lock object is shown.
The channel is enabled via the lock object.
PM350-34x0x_EN