Additional Parameters In Advanced Mode; Night Mode - Niko 350-34001 Manuel Technique

4.10. Additional parameters in Advanced mode

Advanced parameters are made accessible by activating 'Advanced mode' and 'Night mode'.
4.10.1 General / Advanced mode parameters
Parameter Description
Send lux value on KNX bus The measured brightness level is sent on the bus (object 2).
Disable
Enable
Lux value sending mode The measured brightness level is transmitted at regular intervals or when there is a change in lux value.
Lux report when change
Lux report cyclic
Send lux value when value Interval during which the brightness level is transmitted.
varies by Default value: 10%
1-100%
Send lux value every This is the interval at which the lux value is transmitted.
hh:mm:ss
Detector acting on lux value
The detector acts based on an external value (object 3) instead of the built-in brightness sensor.
provided by an external Default value: Disable
device
Disable
Enable

Night mode

With this parameter, night mode can be enabled and a second target brightness level can be activated.
Default value: Disable
Disable
Enable
Day / night mode
With this parameter, you can switch between two setpoints (object 5).
Read after reset
Always day
Day on start
Night on start
Day / night mode object This parameter allows you to change the polarity of the day / night object.
value Default value: Day=1 / Night = 0
Day=1 / Night = 0
Day=0 / Night = 1
Switch between day and Immediately switch between day and night mode or only when there is no presence being detected anymore.
Default value: By next detected motion
night mode
By next detected motion
Immediately
PM350-34x0x_EN
350-34001/350-34002/350-340X3/350-340X4/350-34902
The measured brightness level is not sent on the bus.
The measured brightness level is sent on the bus.
The transmission repetition is transmitted when there is a certain change in lux value (expressed in %).
The transmission repetition is transmitted at a specific interval.
If the brightness level changes above this value, the new value is sent to the detector.
The currently measured value is sent at this interval.
The detector acts based on the value sent by the internal sensor.
The detector acts based on the value received on object 3.
Only one setpoint can be activated.
A second target brightness level can be activated and you can switch between both values.
Object 5 is read after the reset.
Object 5 is ignored and day mode is enabled.
The detector starts in day mode after it has been reset.
The detector starts in night mode after it has been reset.
The object is set to day mode on 1.
The object is set to night mode on 1.
The detector switches between day / night mode at the next motion detection (if it was off first).
The detector immediately switches between day and night mode.
11
EN