Automatic (Dimming Mode) - Niko 350-34001 Manuel Technique

350-34001/350-34002/350-340X3/350-340X4/350-34902
Switch-off lux adjustment
This parameter allows you to activate the switch-off brightness: if there is enough brightness, the detector will not be switched on by motion. If the detector was already switched on,
it will be switched off again.
# lux (0=always ON, 2000 lux max) default
0=0disable
Switch-off delay With this parameter, you can configure the time period between the last motion detected and when the detector is switched off.
hh:mm:ss
Switching or dimming mode This parameter allows you to configure whether the light merely switches on / off or also needs to be dimmable.
Default value: switch
Switch
Dim
Switching / dimming mode This parameter enables objects that can be switched or dimmed manually.
selection via an external
Disable
device
Enable
Switch back to Automatic You can use this parameter to switch from Manual mode back to Automatic mode after the last motion has been detected or via object 22.
Default value: After motion
After motion
Object
Behaviour when motion is
This parameter is used to configure the detector's behaviour when motion is detected.
detected
Switch ON
Switch OFF
Do nothing
LED behaviour after motion
This parameter defines the output value of the detector when motion is no longer detected.
has been detected
Switch ON
Switch OFF
Do nothing
Repeat last command every
With this parameter, you can configure the time period after which the last command needs to repeated.
(00:00:00=disable)
hh:mm:ss
Lock mode With this parameter, you can activate a lock object to disable the channel.
Default value: Disable
Disable
Enable

4.5. Automatic (Dimming mode)

6
EN
If the lux level exceeds this value, the detector will switch off.
This is the time it takes for the detector to switch off after motion has been detected.
The output value of the detector is binary (1/0).
The output value of the detector is expressed in %.
No input objects are present.
Input objects are present.
When motion is no longer detected, the detector will switch back to Automatic mode.
The detector will switch back to Automatic mode via object 22.
When motion is detected, the detector sends a "1" to the output object.
When motion is detected, the detector sends a "0" to the output object.
When motion is detected, the detector sends nothing to the output object.
After motion has been detected, the detector sends a "1" to the output object.
After motion has been detected, the detector sends a "0" to the output object.
After motion has been detected, the detector sends nothing to the output object.
The detector will repeat the last command when the predefined time period has elapsed.
No lock object is shown.
The channel is enabled via the lock object.
PM350-34x0x_EN