Lux Value Switch - Niko 350-34001 Manuel Technique

Parameter Description
Switching or dimming mode
This parameter allows you to configure whether the light merely switches on / off or also needs to be dimmable.
Default value: Switch
Switch
Dim
Type of dimming This parameter is used to configure the dimming range between 0-100% (absolute) or at 1% / sec. (relative).
Relative
Absolute
Switch-on brightness
With this parameter, you can set the brightness value when the light is switched on.
setting
0-100%
Switch-off brightness With this parameter, you can set the brightness value when the light is switched off.
Default value: 0%
setting
0-100%
Switch-off warning
Before completely switching off, the light briefly dims to a minimum level to indicate that it will be switched off soon.
Default value: Disable
Disable
Enable
Warning time During this time frame, the light is dimmed to a minimum level before completely switching off.
hh:mm:ss
Warning brightness setting
This is the warning brightness setting in day mode.
Default value: 20%
0-100%
Warning brightness setting
This is the warning brightness setting in night mode.
(in night mode) Default value: 20%
0-100%

4.6. Lux Value Switch

Parameter Description
Lux level adjustment (10 – This parameter allows you to set the light level at which the detector is switched on.
2000 lux)
# lux
Light intensity fluctuation Light intensity jumps below the set value will be ignored. Sensor hysteresis will compensate for these fluctuations.
Default value: 10%
compensation
1-100%
Activation of the lux value
The lux value switch is active in day mode.
switch function (for day
ON
mode)
OFF
Activation of the lux value The threshold switch is active in night mode.
switch function (for night
ON
mode)
OFF
Activation of the lux value This parameter enables the detector to switch on when the lux level is below setpoint.
switch function (regardless
OFF
of day or night mode)
ON
Repeat last command With this parameter, you can set the time period after which the last command needs to repeated.
every... (00:00:00=Disable)
hh:mm:ss
PM350-34x0x_EN
350-34001/350-34002/350-340X3/350-340X4/350-34902
The output value of the detector is binary (1/0).
The output value of the detector is expressed in %.
The output value is defined in dimming steps (expressed in % of dimming).
The output value is defined in %.
The brightness value is set to a certain percentage when the light is switched on.
The brightness value is set to a certain percentage when the light is switched off.
The light switches off directly.
Before completely switching off, the light is briefly dimmed to a minimum level to indicate that it will switch off soon.
The light is dimmed to a minimum level during the defined time period.
The light is dimmed at the set value before switch-off in day mode.
The light is dimmed at the set value before switch-off in night mode.
The detector will switch on when this value is exceeded.
Light intensity jumps below this level will be ignored.
An OFF telegram is sent when the threshold value in day mode is exceeded during the entire switching time.
No OFF telegram is sent when the threshold value in day mode is not reached during the entire switching time.
An OFF telegram is sent when the threshold value in night mode is exceeded during the entire switching time.
No OFF telegram is sent when the threshold value in night mode is not reached during the entire switching time.
No telegram is sent, regardless of day or night mode.
The light turns, regardless of day or night mode, as long as the measured lux value is lower than the set lux value.
The detector will repeat the last command when the predefined time period has elapsed.
7
EN