Trouble Shooting - Zipper Maschinen ZI-ELB70-2 Manuel D'utilisation

16

TROUBLE SHOOTING

Trouble
Engine does not start
Engine starts and is stalled
immediately
Machine works with interruptions
Smoke
Machine does not work with full
performance
Drill rotates at idling
Drill rotates but has no power
Drill jumps
Should you in necessary repairs not able to properly to perform or you have not
the prescribed training for it always attract a workshop to fix the problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-ELB70-2 32
Possible cause
 Incorrect starting sequence
 Dirty air filter
 No fuel supply
 Fault in the fuel line
 Engine flooded.
 Spark plug connector not placed
on.
 No ignition spark
 Incorrect idle adjustment
 Carburetor incorrectly adjusted
 Spark plug fouled
 Incorrect fuel mixture
 Carburetor incorrectly adjusted
 Machine overloaded
 Dirty air filter
 Carburetor incorrectly adjusted
 Idle speed too high
 Choke is ON
 Drill damaged
 Unsuitable, stony soil
N O T I C E
TROUBLE SHOOTING
Solution
 Observe the correct starting
sequence
 Clean/replace air filter
 Refuel
 Check the fuel line for kinks or
damages
 Screw off, clean and dry the
spark plug. Then pull the
cranking rope several times
and reinstall the spark plug
 Place on the spark plug
connector
 Clean/replace spark plug
 Check ignition cable
 Contact customer service
 Contact customer service
 Clean/replace spark plug
 Check spark plug connector
 Use correct fuel mixture
 Contact customer service
 Too much pressure
 soil too tough
 Clean/replace air filter
 Contact customer service
 Adjust a lower idle speed
 Set Choke to OFF
 Replace a new drill
 impossible
32