Remaining Risk Factors - Zipper Maschinen ZI-ELB70-2 Manuel D'utilisation

 Danger of burns! During the operation flow of hot exhaust gases and engine parts
such as the muffler and engine become hot.
 Never place a hot machine in dry grass or other easily flammable materials.
 After the operation, the machine must cool down. Otherwise there is an imminent
risk of burns
 Ensure yourself that there are neither water or gas pipes nor electric lines
installed underground in the working area.
 Ensure yourself that there are no loose objects lying around in the working area.
 Eliminate high grass, bushes etc. from the immediate working area. They might
be winded up by the rotating drill and block it.
 Take especially care, if the ground contains many stones or roots. An unattended
stalling of the drill might easily cause an accident
 Never leave the machine running unattended!
 Switch off the machine before maintenance or adjustment.
 Never lift or carry the machine with the engine running
 Store in a dry, out of reach of children place and empty Tank completely
A first aid kitin accordance with ISO 3864 shouldalwaysbe readily availablefor
apossible
aidmeasures. Whenrequesting support,provide the following details:
1. Place of accident
3. Number of injured people
13.2

Remaining risk factors

Even if the machine is used as required it is still impossible to eliminate certain residual risk factors
totally. The following hazards may arise in connection with the machine´s construction and design:
 Risk of noise:
Working for a long time can damage your hearing if you do not use a very good hearing protection.
 Risk to the hands or fingers:
Access while it is working in the mowing apparatus. After the operation, the machine must cool down.
Otherwise, there is an acute risk of scalding!
 Vibration:
The declared vibration emission value has been for a standardized test is measured and can be used to
compare one tool with another electric are.
The declared vibration emission value may also be used for a preliminary assessment of exposure.
Warning:
Emission level of vibration can be different from the specified value during the actual use of the electric
tool, depending on the manner in which the power tool is used. When you feel uncomfortable or notice
discoloration of skin on your hands during the use of the machine, stop working immediately. Observe
sufficient break times to rest. Failure to have sufficient break times may result in a hand-arm vibration
syndrome.
The extent of exposure depending on the type of work or machine use should be estimated and
appropriate breaks taken. In this way, the extent of exposure can be considerably reduced over the
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-ELB70-2 26
Emergency procedure
accident. Initiatetheviolationin
N O T I C E
accordance
2. Type of accident
4. Injury type(s)
with thenecessaryfirst
26