Operation; Operation Instructions; Mounting Drill; Refueling - Zipper Maschinen ZI-ELB70-2 Manuel D'utilisation

14

OPERATION

Unpack the machine and check the machine for any transport damage and for completeness of
delivery.
14.1

Operation instructions

The machine is delivered pre-assembled, only the drill must be fitted before

operation.
If the rotating parts (drills) are mounted incorrectly, it can lead to serious accidents!

Check before starting work the correct mounting of the drill.
Mount the drill only with the supplied shear pin and split pin.

Drill deeper holes within 2-3 working steps!

 Is the ground with many roots and / or stones keep extreme caution: Be especially
careful that you do not meet an unexpected blocking of the drill by jamming in a
root or a large stone unprepared.
Before use check the earth auger to dust and dirt particles, particularly the engine

cooling air inlet, carburetor and air filter. Clean if necessary.
 The first 10 hours of operation the machine shall not be operated but only at
medium engine speed
start, as the engine itself as well as the gearing components need a running-in
time. The engine itself reaches its max. capacity after the first 10 hours of
operation. Non-compliance with this instruction reduces your engine lifespan
substantially. To reduce the max. possible engine speed, turn the adjustment knob
(H-5), so that the throttle lever (H-4) cannot be pushed entirely in
14.2 Operation

14.2.1 Mounting drill

To mount the drill (Fig. A) turn the aggregate upside down

Put the drill to the drill adapter that you can plug the shear pin through the holes.

Insert the shear pin (Fig. J;b) through the drill and drill adapter and secure the shear pin with the

split pin.

14.2.2 Refueling

The machine is run by a gasoline (bezenefree engine fuel)-oil mixture. You need for the 2-
Stroke engine a fuel mixture of 40:1.Ensure yourself that no particles get into the fuel tank
when refueling. Use a filter.
ZIPPER MASCHINEN strongly recommends the usage of HQ premixed fuels especially recommended for
2-stroke motors. Many of them keep their consistency even after long periods of storage.
If you prefer to mix your own fuel please use HQ Synthetic Oil for 2-stroke engines.
Synthetic oil reduces accumulation of soot on the spark plug, cylinder, engine cock and exhaust pipe.
This increases the degree of lubrication and prolongs the engines lifespan.
Shake fuel tank prior to every usage! During storage oil descents slowly in the fuel
tank. If you start the engine under this condition, it has barely any lubrication which
would lead to severe engine damage.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-ELB70-2 28
N O T I C E
. Do not operate the engine at max. speed right from the
H I N W E I S
No warranty
OPERATION
28